operating system. If [port] is 0, the change applies to all SAN connections; otherwise the
host type is applied.
Parameter
Port
OS
setNettime [value]
The setNettime command enables or disables timeserver functionality.
SN60023 > setNettime 1
Nettime 1 value = 0 = 0x0
SN60023 >
setNettime [value]
Value
0
1 or 2
" nt "
" autosense/nt "
" aix "
" solaris "
" hp-ux "
" netware "
" gateway "
" switch "
" generic "
" unisys "
" as400 "
" linux "
" adic snc "
" pv-136-fc "
Attention: You must reboot the SNC after executing this command for the
new setting to take effect.
Value
0
Disables timeserver functionality
1
Enables timeserver functionality
Changes will apply to all
FC Connections
Changes will apply to FC
Connection 1 or 2, as
specified
Meaning
page 225