ADIC Scalar 100 User Manual page 219

0 message response generated
value = 30 = 0x1e
SN60023 >
ifShow
The ifShow command is used to show the Ethernet port parameters and status as shown
below. The SNC will show two devices. lnPci is the Ethernet port. lo is the local
loopback port.
SN600752 > ifShow
ibmEmac (unit number 0):
Flags: (0x8063) UP BROADCAST MULTICAST ARP RUNNING
Type: ETHERNET_CSMACD
Internet address: 172.16.76.211
Broadcast address: 172.16.255.255
Netmask 0xffff0000 Subnetmask 0xffff0000
Ethernet address is 00:60:45:17:02:f0
Metric is 0
Maximum Transfer Unit size is 1500
114192 packets received; 364 packets sent
114023 multicast packets received
116 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 32768
0 packets received; 0 packets sent
0 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
value = 29 = 0x1d
SN600752 >
inetstatShow
The inetstatShow command displays statistics about Internet protocol sockets for the
Ethernet network. Interpreting these statistics requires detailed knowledge of Internet
networking protocols. This information may be useful to the LAN administrator.
SN60023 > inetstatShow
Active Internet connections (including servers)
ifShow
page 205