ADIC Scalar 100 User Manual page 228

value = 47 = 0x2f = '/'
SN60023 >
netHelp
The netHelp command displays a list of the Ethernet network commands.
SN60023 > netHelp
arptabShow
ethAddrSet"inetaddr","netmask" - set IP Address
gateAddrGet
gateAddrSet "inetaddr"
host "<func>","hostname","inetaddr"
func - "add" - add to host table
- "delete" - delete from host table
- "list" - list host table
hostNameSet
icmpstatShow
ifShow
inetstatShow
ipstatShow
macShow
mbufShow
route "<func>","destination","gateway"
func - "add" - add route to route table
- "delete" - delete route from route table
- "list" - list route table
tcpstatShow
udpstatShow
See User's Guide for more information
value = 0 = 0x0
SN60023 >
normalBoot
Certain commands and tests are only available in diagnostic mode. Switching to
diagnostic mode saves all configuration parameters so that they are restored before
returning to normal operation. Use the normalBoot command to restore the SNC to
normal operating conditions.
This command is used only to transition an SNC from the special diagnostic mode to
normal operations. It restores the bootline that was copied by diagBoot. The new
persistent device map is erased, and the original map file is renamed config/
page 214
- Display a list of known ARP entries
- Display Default IP gateway
- set Default IP gateway
- set host name
- Display statistics for ICMP
- Display info about network interfaces
- Display all Internet protocol sockets
- Display statistics for IP
- Display Media Access Control Address
- Display mbuf statistics
- Display statistics for TCP
- Display statistics for UDP
netHelp