Figure 3-69: Update Firmware
Restart SNC 5101
After you select an SNC in Tree View, you can use the Controls > Restart SNC 5101
option to reboot it. You can also reboot a selected SNC via the right-click menu. See
Figure 3-70. Restart SNC 5101 is the last option.
Figure 3-70: Right-Click Menu: Restart
Controls Menu Group
the SNC to use the new firmware.
Attention: Restart will immediately stop all I/O activity. Any connected
host must stop sending commands to devices attached to the SNC or it will
cause timeouts or other failures to be reported on the host system.
page 91