Update Drive Firmware From Fmr Tape - ADIC LTO 200D User Manual

The drive takes approximately 20 minutes to complete the tests. If the diagnostics complete successfully, it will loop and
begin again.
5. Press and hold the Unload button for several seconds. When the loop ends, 0 will appear temporarily on the single-character
display. The drive will rewind, then unload the cartridge and exit Maintenance Mode. The front panel indicators will
display the following:
Indicator
Status LED
Single-character display
LCD
followed by:
Indicator
Status LED
Single-character display
LCD
If an error occurs while the drive is running the Drive R/W Diagnostic, the front panel indicators will display the
following:
Indicator
Status LED
Single-character display
LCD
The drive will unload and eject the cartridge, exit Maintenance Mode, and the front panel indicators will display the
following:
Indicator
Status LED
Single-character display
LCD
6. To resolve the error, refer to Table 4-2 Error Codes, later in this chapter. To clear the error, cycle (remove, then reapply)
power to the LTO standalone.

Update Drive Firmware from FMR Tape

To select the Update Drive Firmware from FMR Tape function, perform the following steps:
1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
State, Character, or Message
Off
Off
Passed!
Tape Unloading
State, Character, or Message
Off
Off
Ultrium Tape Drive
Drive Empty
State, Character, or Message
Amber, flashing
5
,
flashing
Error!
Drive Problem
State, Character, or Message
Amber, flashing
5
,
flashing
Ultrium Tape Drive
Drive Empty
Troubleshooting and Diagnostics 29