ADIC Scalar 100 User Manual page 255

-------- SCSI 4 VPD --------
IO Class
IO Type
IO Mfg
Device Index
IO Class Enum
IO Type Enum
Label Index
Bus Id
value = 0 = 0x0
buck172 >
sz filename
"
The sz command initiates a send Zmodem file transfer session. You use this command
when you want to save configuration information to a file in case the SNC needs to be
replaced. The SNC uses Zmodem protocol to upload its persistent address map database
and configuration parameter settings from its nonvolatile flash memory to a file on the
service terminal. After issuing this command, you start the file transfer from the service
terminal by initiating a receive file operation that uses Zmodem protocol.
The filename "config.cfg" is shown in the example below. You can specify a different
name for the file but the name must not exceed 8 characters and it must end in .cfg. See
also the rz command for information about receiving a configuration file.
SN60023 > sz "config.cfg"
Configuration Download Complete: config.cfg
value = 0 = 0x0
SN60023 >
targets
The SNC maintains a list of target devices that are attached to the I/O channels. The
targets command will list each device currently attached, providing descriptions of the
devices.
SN60023 > targets
Idx Tdev
----------------------------------------------|----------------
0 0xc194a400 SNC Local 0252 | Cmd/Cntrl Status 0h
2 0xc1ffc390 SNC 5324 | Tape: Blk Size 32768 , flags 7h
3 0xc1ffc290 SNC 5324 | Changer: flags 7h
value = 4 = 0x4
SN60023 >
sz "filename"
Fixed IO
SCSI
LSI Logic
11
n/a
n/a
03
1.1.1
"
Vendor Product Rev | Type Specific
Idx Device Index in the target list.
Tdev An internal pointer, used for some diagnostic operations
page 241