ADIC Scalar 100 User Manual page 232

rtcSetCurrent
The rtcSetCurrent command is used after the rdate " timeserver " command
in order to synchronize the local Real Time Clock with the timeserver running on a remote
host. Use the date command to see the synchronized settings.
SN60023 > rtcSetCurrent
value = 0 = 0x0
SN60023 >
rz
The rz command initiates a receive Zmodem file transfer session. You use this command
when you want to download a file from the service terminal to the SNC. The file can be
either a firmware or configuration file. After issuing this command, you start the file
transfer from the service terminal by initiating a send file operation that uses Zmodem
protocol.
The example below shows the command when it is used to receive a file that contains
rz
operational firmware. The SNC extracts individual firmware modules from the file and
saves them temporarily in memory. After the file transfer has completed, the SNC copies
the firmware modules to nonvolatile flash memory. The SNC must be rebooted to use the
updated firmware.
SN60023 > rz
**B000000023be50
Firmware Update in Progress....
Found Image File BOOTROM.IMG – loading
.........Found Image File IPOST.IMG – loading
.........Found Image File SPOST.IMG – loading
Firmware Update Complete. Reboot for Update to Take Effect.
value = 0 = 0x0
SN60023 >
The example below shows the rz command when it is used to
receive a file that contains configuration parameters. See also
the sz command for information about sending a configuration
file.
SN60023 > rz
**B000000023be50
Configuration Update in Progress....
Configuration Update Complete. Reboot for Update to Take
Effect.
value = 0 = 0x0
SN60023 >
page 218
rtcSetCurrent