ADIC Scalar 100 User Manual page 250

value = 0 = 0x0
SN60023 >
sysNodeNameModeSet [Mode]
The sysNodeNameModeSet command changes the Fibre Channel Node Name Mode
for the Fibre Channel interface ports. In the default mode (Mode 0), each Fibre Channel
port on the SNC has the same node name. For configurations that require the node name to
be different, use the sysNodeNameModeSet command to change the mode to 1.
An example configuration that requires the Node Name on each Fibre Channel port to be
different is where the host has two Host Bus Adapters (HBAs) installed for redundancy. In
this configuration, each HBA is connected to a different Fibre Channel port on the SNC.
Fail-over software on the host defines one of the HBAs as the primary connection and the
other HBA as a spare. If the primary HBA should fail, the fail-over software routes data
transfers to the SNC through the spare HBA.
If you change the mode, you must reboot the SNC for new setting to take effect.
See also the sysNodeNameModeShow command.
Example:
SN60023 > sysNodeNameModeSet 1
Please REBOOT the box to activate your new mode
value = 0 = 0x0
SN60023 >
sysNodeNameModeShow
The sysNodeNameModeShow command displays the current Fibre Channel Node
Name mode. The default mode is 0. See the sysNodeNameModeSet command for
further information.
page 236
Mode
0 Node name is the same on all Fibre
Channel interfaces (default)
1 Node name is based on port name but
different from port name
Definition
sysNodeNameModeSet [Mode]