Robot Settings - Kemppi AX MIG Welder Operating Manual

Weld data average
Date
Time
System settings
Water cooling
Cable calibration
Device data
Backup
Restore
Factory reset

3.2.12 Robot settings

Robot settings can be accessed via the Settings view menu in AX Manager. The contents of the view varies depending
on the robot communication mode.
© Kemppi
Without slopes / Entire This feature allows the user to change how the weld data aver-
weld ages are calculated: with or without the slope phases in the
Default = Without beginning and in the end of the weld.
slopes This setting affects the calculation of the averages for the fol-
lowing: welding voltage (terminal and arc voltage), welding cur-
rent, welding power and wire feed speed.
Current date Note: The date and time settings are not affected by the NTP
(Network Time Protocol). The user must set the correct date and
Current time
time.​
OFF/AUTO/ON When ON is selected, the coolant is circulated continually. When
Default = AUTO AUTO is selected, the cooler starts to circulate coolant auto-
matically when welding starts and continues for some time after
welding. When the system has cooled down, the cooler stops
automatically.
Start/Cancel The date and time and the calibration information of the pre-
vious calibration is also shown. Refer to "Calibrating welding
cable" on page 94 for cable calibration.
Makes a backup file of the system settings to a USB memory
device.
Restores the saved system settings from a USB memory device.
Start/Cancel Performs a full reset to factory settings.
125
AX MIG Welder
Operating manual - EN
1921900 / 2318