Table of Contents
Advertisement
AX MIG Welder
Operating manual - EN
3.2.8 Tools
Gas test
Gas test is used to flush the previous shielding gas, run new shielding gas into the system, and test that the shielding
gas flows through the system properly.
The gas test time can be adjusted by selecting the Gas test time button.
R500 Wire Feeder EUR+: If the Gas flow sensor is ON, the gas flow rate is displayed (refer also to "Robot settings" on
page 125).
Wire inch
Wire inch drives the filler wire forward or backward as long as the Forward/Backward button is pressed. Releasing the
button takes you back to the Tools view and resets the wire feed speed to the default value.
The wire feed speed can be adjusted by selecting the Wire inch button.
A counter shows how much wire has been driven. The counter helps to estimate when the filler wire will reach the gun
end (forward) or come out of the wire feed rolls (backward).
Air blow (available in R500 Wire Feeder EUR+ only)
Air blow is used to clean the welding gun with compressed air.
The air blow time can be adjusted by selecting the Air blow button.
3.2.9 Robot status
The robot status view displays the status communication between the power source and the robot. For more inform-
ation on status and control parameters, refer to "Status information" on page 85 and "Control information" on page 84.
119
© Kemppi
1921900 / 2318
Advertisement
Table of Contents
