Kemppi AX MIG Welder Operating Manual page 120

Parameter
General
Communication
OK
Power source
Error
System
Power source
Arc on
Cycle on
Collision
Sensed with wire /
gas nozzle
Water flow
© Kemppi
Description
Green light: The status data transfer between the welding system and the robot works.
No light: The status data transfer between the welding system and the robot does not work.
No light: No errors are active.
Red light: There is an error in the welding system that prevents welding.
Select the error symbol for more information.
Green light: The welding system is ready for welding. All system devices are correct and working.
No light: The welding system is not ready for welding.
Green light: The power source is ready to start a new weld.
No light: The power source is not ready to start a new weld.
Green light: The welding arc is established.
No light: The welding arc is not established.
Green light: The welding cycle is in progress (the pre gas and post gas phases are included in the welding
cycle).
No light: The welding cycle is complete.
Red light: A collision is detected.
No light: No collision is detected.
Green light: A contact between the touch sensor (gas nozzle or wire) and the work piece has been detected.
No light: No touch is sensed.
Green: Coolant is circulating.
No light: Coolant is not circulating.
120
AX MIG Welder
Operating manual - EN
1921900 / 2318