Connecting To Ax Manager User Interface - Kemppi AX MIG Welder Operating Manual

2.2 Connecting to AX Manager user interface

This section describes how to connect to the AX Manager user interface for the first time (or after a factory reset) with
the default network settings.
The RCM serial number and security code can be found in the serial number sticker on the RCM device.
WLAN access point mode (RCM+ only)
1. Establish a wireless connection to AX Manager with your PC / tablet / mobile device.
>> The WLAN default name (SSID) is AX<RCM serial number>, e.g., AX1234567​ .
>> The default password is KemppiAX<RCM security code>, e.g.,KemppiAX1234.
2. Once connected (connecting may take a few seconds), open an internet browser and enter the default network
address AX<RCM serial number>.local.
>> The web address for RCM is AX<RCM serial number>.local, e.g., AX1234567.local.​
>> You are now connected to AX Manager.
If the network address AX<RCM serial number>.local does not work, use the numeric IP address (192.168.3.1.).
Ethernet port 1, DHCP server mode
1. Connect your PC to the Ethernet port 1 (*) on the rear of RCM.
2. Open an internet browser and enter the default network address AX<RCM serial number>.local.
>> You are now connected to AX Manager.
If the network address AX<RCM serial number>.local does not work, use the numeric IP address (192.168.2.1.).
Tip: You can also connect to RCM via the Ethernet port 2 inside RCM (DHCP client mode). Using the Ethernet
port 2 depends on the user's network and settings and requires knowing the RCM's LAN address received from
the network or assigned statically.
© Kemppi
23
AX MIG Welder
Operating manual - EN
1921900 / 2318