Table of Contents
Advertisement
2.3 Installing equipment on stand (optional)
The welding equipment can be installed with or without the cooling unit on a dedicated stand (available as an access-
ory).
For more information on installing the power source on top of the cooling unit, refer to "Installing cooling unit
(optional)" on the next page.
Tools needed:
1.
Install the cooling unit on the stand so that the fixing plates align and go into their slots. Fix the cooling unit to the
stand with two screws in the front (M5x12) and two screws in the rear (M5x12).
2.
Install the power source on top of the cooling unit and fix the units together with two screws in the front and two
screws in the rear. Refer to "Installing cooling unit (optional)" on the next page for installation details.
For installing RCM on top of the power source, refer to "Installing RCM on power source (optional)" on page 28.
© Kemppi
24
AX MIG Welder
Operating manual - EN
1921900 / 2318
Advertisement
Table of Contents
