Removing Fieldbus Module - Kemppi AX MIG Welder Operating Manual

2.11 Removing fieldbus module

This section describes how to remove a fieldbus module. For instructions on removing and attaching the RCM top cover,
refer to "Removing and attaching RCM top cover" on page 31.
Tools needed:
1. Remove the cable clamp by unscrewing the fixing screws.
2. Remove the fieldbus module cable from the fieldbus module.
Depending on the fieldbus module, the cable may be different.
3. Loosen the fieldbus module's fixing screws and pull the fieldbus module out of the connector.
The screws must be loose enough to allow the module to be removed.
© Kemppi
38
AX MIG Welder
Operating manual - EN
1921900 / 2318