Control Panel: System Settings - Kemppi Master M 205 Operating Manual

Crater fill
- Crater fill start level
- Crater fill time
- Crater fill end level
- Crater fill 4T timer
Pulse welding parameters (Master M 205 only)
The parameters listed here are available for adjustment with the pulse welding process in addition to the MIG and 1-MIG weld-
ing parameters. For more information on the processes, refer to "Additional guidance to functions and features" on page 47.
Parameter
Pulse current %

3.3.7 Control panel: System settings

Changing settings
1. Turn the right control knob to highlight the desired settings parameter.
2. Press the right control knob to select the settings parameter for adjustment.
3. Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4. Confirm the new value / selection by pressing the right control knob.
Settings
Parameter
Remote
Remote selection
© Kemppi
ON/OFF
Default = OFF
10 ... 150 %, step 1
Default = 100 %
0.1 ... 10.0 s, step 0.1
Default = 1.0 s
10 ... 150 %, step 1
Default = 10 %
ON/OFF
Parameter value
-10 ... 15 %
Default = 0 %
Parameter value
ON/OFF
Gun remote
44
Operating manual - EN
When welding with high power, a crater
is usually formed at the end of the weld.
The Crater fill function decreases the
welding power / wire feed speed at the
end of the welding job so that the crater
can be filled using a lower power level.
Crater fill duration, wire feed speed and
voltage are preset by the user. The crater
fill start level cannot be smaller than the
crater fill end level.
When the 4T timer is set to ON, releasing
the trigger during crater fill does not end
welding.
Description
The pulse current relative to the base cur-
rent in pulse welding.
Description
Select whether remote is used.
If Remote is ON, then GXR10 gun remote
control is used for controlling the wire
feed speed or memory channels.
Master M 205, 323
1922130 / 2313