Table of Contents
Advertisement
2.9 Connecting PE (protective earth) wire (optional)
If RCM is installed on the power source with the official fixing bracket, the PE wire is not needed.
For the RCM part descriptions, refer to "RCM (Robot Connectivity Module)" on page 18.
For removing and attaching the RCM top cover, refer to "Removing and attaching RCM top cover" on page 31.
1.
Connect the PE cable to the DIN rail mount terminal block.
2.
Pass the PE wire through a cable inlet and secure the PE wire by tying it to the circuit board mounts with cable ties.
© Kemppi
35
AX MIG Welder
Operating manual - EN
1921900 / 2318
Advertisement
Table of Contents
