Kemppi AX MIG Welder Operating Manual page 130

Comm 2 mode
Profibus
This table lists the Profibus fieldbus settings.
Parameter
Identification information
Manufacturer
PNO Ident number
Order ID
Serial number
Hardware version
Module version
Configuration parameters
Node address
DeviceNet
This table lists the DeviceNet fieldbus settings.
Parameter
Identification information
ODVA Vendor ID
ODVA Device type
Product code
Serial number
Module version
Product name
Configuration parameters
Node address
Baud rate
© Kemppi
Automatic Ethernet speed / duplex for port 2.
10 MBit Half Duplex In the Automatic mode the fieldbus module chooses the correct mode automatically.
10 MBit Full Duplex
100 MBit Half Duplex
100 MBit Full Duplex
Value
0x0368
0x11BF
Example: PSNK0012345
Example: 1
Example: 1.23.4
0...125
126 = SSA mode
Value
1403
100
3
Example: 750012345
Example: 1.23.4
AX MIG Welder
0...63
125 kbps
250 kbps
500 kbps
Auto
Description
Vendor identifier assigned to Kemppi by PNO (PROFIBUS
Nutzerorganisation).
Manufacturer-specific identification number.
Fieldbus module ordering code.
Serial number of the welding power source.
Hardware version of the fieldbus module.
Software version of the fieldbus module.
The node address of the fieldbus module.
In the SSA mode the node address is defined automatically.
Description
Vendor identifier assigned to Kemppi by ODVA.
Identifier of the type of the welding system.
Code from which the robot identifies the welding system.
Serial number of the welding power source.
Software version of the fieldbus module.
Name of the welding system.
The node address of the fieldbus module.
The rate at which information is transferred in a com-
munication channel.
130
AX MIG Welder
Operating manual - EN
1921900 / 2318