Installing And Cleaning Power Source Air Filter (Optional) - Kemppi AX MIG Welder Operating Manual

4.5 Installing and cleaning power source air filter (optional)

An optional power source air filter can be purchased separately. The air filter comes with a fixed casing designed to be
mounted directly onto the power source air intake.
Using the optional air filter decreases the rated power levels of the power source as follows: 60% >>> 45% and 100%
>>> 100%-20A (output 40 °C). This is due to the slightly obstructed cooling air intake of the power source unit.
Tools needed:
Installation and replacement
1. Place the air filter assembly onto the power source air intake, and lock it in place with the clips on the edge of the
casing.
© Kemppi
154
AX MIG Welder
Operating manual - EN
1921900 / 2318