2.6 Mounting wire feeder on robot arm
To mount the wire feeder on the robot arm, use a two-part mounting bracket. Mounting brackets are available for the
most commonly used welding robots. For a complete list of the available brackets, refer to the product catalog at
Kemppi.com.
1.
Fasten the upper part of the bracket to the bottom of the wire feeder with bolts.
Use the insulating bushes with the bolts.
2.
Fasten the lower part of the bracket to the robot arm with bolts.
3.
Place the upper part of the bracket to the lower part and secure them with bolts.
© Kemppi
30
AX MIG Welder
Operating manual - EN
1921900 / 2318