Device Settings - Kemppi AX MIG Welder Operating Manual

WLAN IP configuration (RCM+ only) - access point mode
Parameter
WLAN
MAC address
WLAN mode
SSID
IP address
Security protocol
Password
LAN 1 / LAN 2 IP configuration
Parameter
LAN 1
LAN 2
MAC address
IP address
Subnet mask
Gateway
Primary DNS
Secondary DNS
NTP (Network Time Protocol) configuration
Parameter
NTP address
NTP last sync

3.2.11 Device settings

Device settings can be accessed via the Settings view menu in AX Manager.
© Kemppi
Value Description
ON/OFF
The unique address of RCM.
Access point RCM acts as an access point to which other devices (PC, mobile
device) can connect.
E.g. AX123456 The SSID (Service Set Identifier), i.e. the name of the WLAN net-
work offered by RCM.
Default = 192.168.3.1 RCM WLAN IP address.
WPA2 Security protocol for the WLAN.
WLAN password.
Value Description
DHCP server Used as a service port to provide access to AX Manager. Not con-
figurable by the user.
DHCP server: The DHCP server allocates an IP address to RCM.
Static IP / Client / DHCP Static IP: RCM is allocated a fixed IP address.
server Client: RCM requests an IP address from the DHCP server during
Default = DHCP client network initialization.
The unique address of RCM.
Default IP addresses: IP address for RCM.
LAN 1 = 192.168.2.1
LAN 2 = No default IP
address
Default = 255.255.255.0 RCM subnet mask.
E.g. 10.0.0.125 / Empty IPv4 address of the gateway (if used).
E.g. 10.0.0.125 / Empty IPv4 address of Primary DNS server.
E.g. 10.0.0.125 / Empty IPv4 address of Secondary DNS server.
Value Description
Default = 1.kemppi.- NTP is used to synchronize the time used for WeldEye. This is
pool.ntp.org the address of the NTP server.
The date and time of the last successful time synchronization.
123
AX MIG Welder
Operating manual - EN
1921900 / 2318