Network Settings - Kemppi AX MIG Welder Operating Manual

Gas flow
Robot
Robot ready
Start welding
Simulation
Touch sensing ON
Gas nozzle
Gas blow
Wire inch forward
Wire inch back-
ward
Air blow (Wire
Feeder 500 EUR+
only)

3.2.10 Network settings

Network settings can be accessed via the Settings view menu in AX Manager.
© Kemppi
Green light: The gas flow rate is above the minimum gas flow rate set in AX Manager. Note that if the gas flow
sensor (available in R500 Wire Feeder EUR+ only) is set to OFF, this status is OK even if the gas flow rate is
below the gas flow rate set in AX Manager (for more information, refer to "Robot settings" on page 125).
Yellow light: The gas flow rate is below the minimum gas flow rate set in AX Manager.
No light: There is no gas flow.
Green light: The robot is ready to start a new weld. Note that in those fieldbus control tables that do not sup-
port this field, the status is always ready.
No light: The robot is not ready to start a new weld.
Green light: The robot has requested welding or simulation if the simulation mode is on.
No light: The robot has not requested welding or simulation.
Green light: The simulation mode is on. The StartWelding control bit controls the simulation cycle. In sim-
ulation mode the arc is not lit and wire is not fed.
No light: The simulation mode is off. The StartWelding control bit controls the welding cycle.
Green light: Touch sensing is used.
No light: Touch sensing is not used.
Green light: Gas nozzle is used for touch sensing.
No light: Filler wire is used for touch sensing.
Green light: The shielding gas valve is open for gas blow.
No light: The shielding gas valve is closed.
Green light: The wire inch forward function is ON.
No light: The wire inch forward function is OFF.
Green light: The wire inch backward function is ON.
No light: The wire inch backward function is OFF.
Green light: The compressed air valve is open. The compressed air valve cannot be opened during welding or
simulation.
No light: The compressed air valve is closed.
121
AX MIG Welder
Operating manual - EN
1921900 / 2318