Routing Cables Into Rcm - Kemppi AX MIG Welder Operating Manual

2.8 Routing cables into RCM

RCM has several cable inlets for different sized cables: one cable inlet with a cable clamp (used for strain relief) and three
cable inlets with grommets.
For instructions on removing and attaching the RCM top cover, refer to "Removing and attaching RCM top cover" on
page 31.
Routing cable through cable inlet with cable clamp
1. Remove the cable clamp by unscrewing the fixing screws.
2. Route the cable through the inlet.
3. Reattach the cable clamp and tighten the fixing screws.
Routing cable through cable inlet with grommet
Puncture the grommet and route the cable through the inlet.
© Kemppi
33
AX MIG Welder
Operating manual - EN
1921900 / 2318