Kemppi AX MIG Welder Operating Manual page 110

Hot start
- Hot start level
- Hot start time
Wise feature
Wire feed speed
Wire feed speed limit min
Wire feed speed limit max
Current
Fine tuning
Dynamics
Crater fill
- Crater fill start level
- Crater fill time
- Crater fill end level
Post current
Wire feed end step
© Kemppi
ON/OFF
Default = OFF
-50 ... +200 %, step 1
Default = 140
0.1 ... 9.9 s, step 0.1
Default = 1.2 s
None, WiseFusion, WisePenetration+,
WiseSteel
0.5 ... 25 m/min, step 0.05 or 0.1
Default = 5.00 m/min
Min/Max = 0.5 ... 25 m/min, step 0.1
Default = 0.5 m/min
Min/Max = 0.5 ... 25 m/min, step 0.1
Default = 25 m/min
10 ... machine size A, step 1
Default = 50 A
Example: -10.0 ... +10.0 V *,
step 0.1
-10.0 ... +10.0, step 0.2
Default = 0
ON/OFF
10 ... 150 %, step 1
Default = 100
0.1 ... 10.0 s, step 0.1
Default = 1.0 s
10 ... 150 %, step 1
Default = 30
-30 ... +30
OFF/ON
Default = OFF
110
Operating manual - EN
Welding function that uses higher or
lower wire feed speed and welding cur-
rent at the start of the weld. After the Hot
start period the current changes to nor-
mal welding current level. This facilitates
the start of the weld especially with alu-
minum materials. The Hot start level and
time are preset by the user.
When selected, a list of available Wise fea-
tures is opened for selection. For more
information, refer to "Additional guid-
ance to functions and features" on
page 137.
(Not available with WiseRoot+, WiseTh-
in+, MAX Cool, MAX Speed and MAX Pos-
ition.)
Wire feed speed adjustment. When the
wire feed speed is less than 5 m/min, the
adjustment step is 0.05 and when the
wire feed speed is 5 m/min or more, the
adjustment step is 0.1.
Minimum and maximum limits for the
wire feed speed adjustment.
Welding current adjustment. With
WisePenetration+ only.
Fine tuning of the welding voltage.
* The voltage range for fine tuning is
defined by the active welding program.
Controls the short circuit behavior of the
arc. The lower the value the softer the arc,
the higher the value the rougher the arc.
When welding with high power, a crater
is usually formed at the end of the weld.
The Crater fill function decreases the
welding power / wire feed speed at the
end of the welding job so that the crater
can be filled using a lower power level.
With 1-MIG process, Crater fill start level,
time and end level are preset by the user.
Post current setting affects the wire
length at the weld end, for example to
prevent the wire from stopping too close
to the weld pool. This also enables the
optimum wire length for the start of the
next weld.
Wire feed end step feature prevents the
filler wire from sticking to the work piece
when the welding ends. This is accom-
plished by pulling the wire back briefly.
AX MIG Welder
1921900 / 2318