Timing Diagrams; Welding Start And Stop Timing - Kemppi AX MIG Welder Operating Manual

2.28 Timing diagrams

This section describes the timing of certain functions when controlled by the robot.
"Welding start and stop timing" below
"Memory channel change timing" on the next page
"Wire inch timing" on the next page
"Touch sensor timing" on page 90
"Stop switch response timing" on page 91

2.28.1 Welding start and stop timing

Welding start timing
Item Description
A Cycle on
B Arc establishment
*The maximum time is limited by the wire feeding timeout.
Welding stop timing
Symbol
A
B
* If the post gas time is less than 100 ms, the minimum cycle OFF time is determined by the power source shutdown
time.
© Kemppi
Min Typical
5 30
100 Pre gas time + distance of the wire from the work piece + 150
Description Min
Arc OFF time 60
Cycle OFF time 100*
Typical
70
Post gas time + 20
88
AX MIG Welder
Operating manual - EN
Max Units
50 ms
* ms
Max Units
- ms
- ms
1921900 / 2318