Kemppi AX MIG Welder Operating Manual page 122

Changing settings
1. To access your network's IP settings, select 'Configure'.
2. Select the settings parameter for adjustment.
3. Select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Network settings table below for more
details.
4. Confirm the new value / selection and close the adjustment view by selecting 'OK'.
WLAN IP configuration (RCM+ only) - client mode
Parameter
WLAN
MAC address
WLAN mode
SSID
IP address
Subnet mask
Gateway
Primary DNS
Secondary DNS
Security protocol
Password
© Kemppi
Value Description
ON/OFF
The unique address of RCM.
Client Client mode: RCM connects to the existing WLAN network.
Local wireless network's SSID (Service Set Identifier), i.e. the
name of your WLAN network.
E.g. 172.31.2.121 RCM WLAN IP address.
E.g. 255.255.252.0 RCM subnet mask.
E.g. 172.31.0.1 IP address of the WLAN router.
E.g. 8.8.8.8 IPv4 address of Primary DNS server.
E.g. 8.8.8.4 IPv4 address of Secondary DNS server.
OFF/WEP/WPA2 Security protocol for wireless networks.
WLAN password.
122
AX MIG Welder
Operating manual - EN
1921900 / 2318