Weld Data Selections (Weld Data); Setup Selections (Settings) - Kemppi MagTrac F 61 Manual

3.3.11 Weld data selections (WELD DATA)

MagTrac F 61 records useful information about the latest welding session. Select Weld data
menu to check the data.
Menu item
TOT ARC (m)
TOT ARC (min, s)
CURRENT
VOLTAGE
HEAT
RESET WELD DATA

3.3.12 Setup selections (SETTINGS)

Select this menu to check or change the MagTrac F 61 settings. The settings are stored in the
carriage memory.
Menu item
CONTRAST
RESTORE SETTINGS
PANEL INFO
Initial parameter settings
When you use the RESTORE SETTINGS function, the parameter settings are restored to the
following values:
Parameter
ARC ON
DIRECTION
CONTRAST
CYCLE WELD
WELD LENGTH
IDLE LENGTH
CYCLE COUNT
LAST WELD LENGTH
TOT ARC
TOT ARC
CURRENT
VOLTAGE
HEAT
© Kemppi Oy / R01
Description
Length of the latest weld.
Total welded length of the latest welding session.
Does not include the non-weld length in cycle welding.
Total time of the latest welding session.
Does not include the non-weld time in cycle welding.
Average welding current during the latest welding session.
Average welding voltage during the latest welding session.
Heat input in the latest welding session in kJ/mm.
This resets all weld data settings.
Values Description
Change the contrast of the carriage display.
YES, NO Restore the parameter values to their initial settings.
PANEL SW Open information about the carriage software: Control panel
SYSTEM SW version, system version and the date of the carriage software.
PRG DATE
Factory value
OFF (welding arc is off)
RIGHT (carriage travels to the right)
20 (contrast of the control panel display)
OFF (cycle welding is not in use)
50 mm (length of the welded section in cycle welding).
50 mm (length of the non-welded section in cycle welding).
CONT (cycle welding continues until it is stopped )
0 mm
0 mm (total arc length in the latest welding session)
0 min 0 s (total arc time in the latest welding session)
0 A (average current in the latest welding session)
0 V (average voltage in the latest welding session)
0.0 kJ/mm (heat input in the latest welding session)
EN
13