Kemppi AX MIG Welder Operating Manual page 124

Changing settings
1. Select the settings parameter for adjustment.
2. Select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Device settings table below for more
details.
3. Confirm the new value / selection and close the adjustment view by selecting OK.
Device settings
Parameter
Wire feeder
Safe wire inch
Wire retract
- Retract delay
- Retract length
User interface
Language
Weld data time
© Kemppi
Parameter value Description
OFF/ON When ON, and the arc doesn't ignite, the filler wire is fed 5 cm.
Default = ON When OFF, 5 m of filler wire is fed.
OFF/AUTO This is an automatic wire retract feature. Once the arc is extin-
Default = OFF guished, the wire is retracted for additional safety. The user can
change the wire retract delay and length settings.
2...10 s, step 1
Default = 5 s
1...10 cm, step 1
Default = 2 cm
Available languages
1 ... 30 s This defines if and how long the weld data summary is shown
0 = OFF after each weld.
Default = 5 s
124
AX MIG Welder
Operating manual - EN
1921900 / 2318