Kemppi AX MIG Welder Operating Manual page 129

Comm 2 mode
Connection timeout
Process active timeout
EtherNet/IP
This table lists the Ethernet/IP fieldbus settings.
Parameter
Identification information
ODVA Vendor
ID
ODVA Device
type
Product code
Serial number
Product name
Module version
MAC address
Configuration parameters
IP address con-
figuration
IP address
Subnet mask
Gateway
DNS 1
DNS 2
Hostname
Domain
Comm 1 mode
© Kemppi
Automatic
10 MBit Half Duplex
10 MBit Full Duplex
100 MBit Half Duplex
100 MBit Full Duplex
1 ... 65535 s
0 = Disabled
1 ... 65535 ms
0 = Disabled
Value Description
0x057B Vendor identifier assigned to Kemppi by ODVA.
0x0064 Indication of the general type of the welding system.
3 Code from which the robot identifies the welding system.
Example: 750012345 Serial number of the welding power source.
AX MIG Welder Name of the welding system.
Example: 1.23.4 Software version of the fieldbus module.
Example: Unique address identifier of the fieldbus module's Ethernet port.
AA:BB:CC:DD:EE:FF
Client / Static IP Client: The IP address parameter values come from the DHCP server.
Static IP: The IP address parameter values must be entered manually.
Customer-specific IPv4 address for the fieldbus module.
Subnet mask for the fieldbus module.
IPv4 address of the gateway (if used). This field can be empty.
IPv4 address of the primary DNS server. This field can be empty.
IPv4 address of the secondary DNS server. This field can be empty.
Host name limited to 64 characters. This field can be empty.
Domain name limited to 48 characters. This field can be empty.
Automatic Ethernet speed / duplex for port 1.
10 MBit Half Duplex In the Automatic mode, the fieldbus module chooses the correct mode automatically.
10 MBit Full Duplex
100 MBit Half Duplex
100 MBit Full Duplex
Ethernet speed / duplex for port 2.
In the Automatic mode, the fieldbus module chooses the cor-
rect mode automatically.
Time in seconds that a Modbus connection can be open
without a function (read or write) before the module closes the
connection.
Time in milliseconds that the fieldbus module remains in active
state after the last modbus message was received. If the mod-
bus connection is lost during welding, the equipment stops
welding when the module's state changes from active to inact-
ive.
129
AX MIG Welder
Operating manual - EN
1921900 / 2318