Table of Contents
Advertisement
To change the control panel settings and welding parameters, refer to "Manual control panel: Settings" on the next
page.
X5 Wire Feeder 200 Manual control panel (X5 FP 200R)
1.
Left control knob
>> In MIG mode: Wire feed speed
>> In MMA mode: Welding current adjustment
>> In Gouging mode: Current adjustment
2.
Right control knob
>> In MIG mode: Welding voltage adjustment
>> In MIG mode (push button): Switch between welding voltage and dynamics adjustment
>> In MMA mode: Dynamics adjustment
3.
Trigger logic selection
>> Switches between 2T and 4T trigger logic modes
4.
Welding process / operation mode selection
>> Switches between MIG, MMA and Gouging modes
5.
Home button
>> Switches to the default welding view/mode
6.
Weld data button
>> Shows the duration, current and voltage of the last weld
7.
Settings menu button
8.
Gas test button
>> Tests the shielding gas flow and flushes the gas line
9.
Wire inch button
>> Drives the filler wire forward (with arc off)
10. Main display
>> Shows the wire feed speed, current and/or voltage (content shown depends on the welding process selected).
To change the control panel settings and welding parameters, refer to "Manual control panel: Settings" below.
3.2.1 Manual control panel: Settings
To enter and use Settings menu:
© Kemppi
75
X5 FastMig
Operating manual - EN
1920960 / 2144
Advertisement
Table of Contents
