Kemppi AX MIG Welder Operating Manual page 58

3. Detach the pressure roll mounting pins and drive roll mounting caps.
4. Install the drive rolls. Align the cut on the drive rolls' bottom with the pin on the drive shaft.
5. Attach the drive roll mounting caps.
6. Install the pressure rolls and mounting pins (there are no alignment cuts on the bottom of the pressure rolls).
7. Continue to installing the filler wire (refer to "Installing wire" on page 62) or close the locking arms and pressure
handles on the feed rolls.
© Kemppi
58
AX MIG Welder
Operating manual - EN
1921900 / 2318