Table of Contents
Advertisement
5.
In AX Manager, go to Settings - Device settings and select Cable calibration and follow the on-screen instruc-
tions.
6.
Check the measured values in AX Manager and repeat calibration if necessary (if, for example, the calibration failed
due to poor contact between the contact tip and the work piece).
7.
After calibration, lift the welding gun from the work piece, run the wire out of the contact tip and reattach the gas
nozzle.
© Kemppi
95
AX MIG Welder
Operating manual - EN
1921900 / 2318
Advertisement
Table of Contents
