Installing Fieldbus Module (Optional) - Kemppi AX MIG Welder Operating Manual

2.10 Installing fieldbus module (optional)

Fieldbus communication between the welding system and the robot can be implemented with Anybus CompactCom
M40 fieldbus modules (Anybus is a registered trademark of HMS Industrial Networks). The supported fieldbuses are:
• EtherNet/IP
• EtherCAT
• Profinet
• Modbus TCP
• DeviceNet
• Profibus
This section describes how to install a fieldbus module. In these instructions the fieldbus module cable is routed through
the cable inlet with a cable clamp. For information on other cable inlets in RCM, refer to "Routing cables into RCM" on
page 33.
For instructions on removing and attaching the RCM top cover, refer to "Removing and attaching RCM top cover" on
page 31.
Tools needed:
1. Push the fieldbus module into the fieldbus slot (*). Fasten the fixing screws to secure the fieldbus module in place.
© Kemppi
36
AX MIG Welder
Operating manual - EN
1921900 / 2318