Table of Contents
Advertisement
1.
Push the shielding gas hose (1) to the connector so that it locks down.
2.
Connect the wire feeder control cable (2) to the connector.
3.
R500 Wire Feeder EUR+ : To use the WiseThin+ or WiseRoot+ process, connect the voltage sensing cable from the
workpiece (3) to the connector.
4.
R500 Wire Feeder EUR+ : To use the WiseThin+ or WiseRoot+ process, connect the voltage sensing cable from the
power source (X5 Pulse+ power sources only) to the connector (4).
5.
R500 Wire Feeder EUR+: To use gun cleaning with compressed air, connect the compressed air hose (5) to the inlet
connector.
6.
Connect the wire conduit (6) to the connector.
© Kemppi
50
AX MIG Welder
Operating manual - EN
1921900 / 2318
Advertisement
Table of Contents
