Table of Contents
Advertisement
1.5 RCM (Robot Connectivity Module)
RCM handles the communication between the welding system and the robot.
For connecting cables, refer to "Connecting cables to power source and RCM" on page 51.
1.
Wire feeder control cable connector
2.
Reserved for future use
3.
Power source control cable connector
4.
Reserved for future use
5.
Touch sensor negative (-) connector
6.
Cable inlet (with grommet)
7.
Ethernet port
8.
USB port
9.
Cable inlet with cable clamp
10. Cover fixing screws
11. Alignment holes and screws (for securing the cover in place).
Inside RCM
1.
S1 button (forced factory reset, refer to "Troubleshooting" on page 149)
2.
Indicator LEDs
3.
Touch sensor status fast output terminal
4.
Add-on card slots
5.
Fieldbus module slot
6.
Door switch terminal
© Kemppi
18
AX MIG Welder
Operating manual - EN
1921900 / 2318
Advertisement
Table of Contents
