Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kemppi A7 Cooler
Summary of Contents for Kemppi A7 Cooler
- Page 1 A7 MIG Welder A7 Cooler...
-
Page 2: Table Of Contents
..................© Kemppi Oy 2016... -
Page 3: Introduction
1.1 General Important notes Congratulations on choosing the A7 Cooler cooling A7 Cooler is used for liquid cooling of welding gun. It is unit. Used correctly, Kemppi products can significantly designed for Kemppi's robotic welding equipment A7 increase the productivity of your welding, and provide Items in the manual that require particular attention in MIG Welder, but it can also be used in manual welding. -
Page 4: Installation
It is important to make correct reference to the serial number of the product Back side when making repairs or ordering spare parts. Mains voltage connection cable Control cable Cooling water output hose Cooling water input hose © Kemppi Oy 2016 A7 Cooler 1636... -
Page 5: Preparing For Operation
The connection can be established through the base of the power supply when the devices are separated or through the right side of the A7 Cooler unit by removing the right side plate. © Kemppi Oy 2016... - Page 6 When selected, the operation of the cooling unit is automatic, starting when welding commences. When welding stops the pump will continue operation for approx. 5 min, so reducing the gun and the cooling liquid to ambient temperature. © Kemppi Oy 2016 A7 Cooler 1636...
- Page 7 GAS TEST After completing the preparations explained above, the device is ready for welding. Before welding, read the operating instructions. PANEL SF 52W/SF 53W and MS 200/MS 300 SF 51 MINILOG POWER m/min POWER © Kemppi Oy 2016 A7 Cooler 1636...
-
Page 8: Operation
The overheat signal lamp is lighting when temperature control of the machine has detected cooling water The A7 Cooler cooler operation is controlled by the overheat. The ventilator cools down the machine and microprocessor of the power supply. The cooler pump when the lamp goes out welding can be started again. -
Page 9: Maintenance
• Check water level and input flow, add liquid if needed. • Check cables and connections. Tighten, if necessary and replace defect parts. • Check that there are no leakages in the cooling water hoses. © Kemppi Oy 2016 A7 Cooler 1636... -
Page 10: Flow Switch Adjustment
• Check the liquid hoses for damages. • Remove any hose blockages. • Check water circulation, add liquid if needed. 2,5 1,6 For further information and assistance, contact your nearest Kemppi service workshop. 2,5 1,6 © Kemppi Oy 2016 A7 Cooler... -
Page 11: Disposal Of The Machine
250 W decommissioned unit to a regional collection center, Cooling power 1 kW as per the instructions of local authorities or a Kemppi representative. By applying this European Directive you Start pressure, max. 0.4 MPa will improve the environment and human health. - Page 12 And you know.