Wire Feeder Peripheral Connector; Wire Feeder Control Cable Connector - Kemppi AX MIG Welder Operating Manual

For installing the feed rolls, refer to "Installing feed rolls" on page 57.
For installing the wire guide tubes, refer to "Installing wire guide tubes" on page 52.

1.3.2 Wire feeder peripheral connector

This section describes the order and purpose of the pins in the peripheral connector used for connecting welding gun
auxiliary products.
A. Reserved for future use
B. Reserved for future use
C. Supply (+24 V)
>> for a collision sensor with LED status indicators
D. Wire inch input
>> for a welding gun's wire inch button
E. Collision sensor input
>> for a collision sensor (only the gun mounts T1 and T2 feature a collision sensor)
F. Touch sensor output (+50...+200 V)
>> for touch sensing with gas nozzle (ensure that your gun supports touch sensing with gas nozzle)
G. Reserved for future use
H. Supply GND
>> for a welding gun's wire inch button
>> for a collision sensor
I. Reserved for future use
J. Reserved for future use.

1.3.3 Wire feeder control cable connector

This section describes the purpose and order of the pins in the wire feeder's control cable connector.
© Kemppi
14
AX MIG Welder
Operating manual - EN
1921900 / 2318