General - Kemppi AX MIG Welder Operating Manual

1. GENERAL

These instructions describe the integration and use of AX MIG Welder equipment. The equipment consists of a welding
power source, wire feeder, RCM (Robot Connectivity Module) and cooling unit (optional) designed for robotic MIG/MAG
welding. The user interface, AX Manager, can be accessed with an internet browser.
AX MIG Welder can be integrated with all major robot brands. For robot-specific information, refer to the robot man-
ufacturer's operating instructions.
The AX MIG Welder integration consists of the following general steps:
1. Install the hardware
>> Make sure all components are intact.
>> Install the power source mains plug and cooling unit, if any.
>> Attach all necessary components to the robot and welding cell.
>> Connect cables.
>> Turn on the welding system.
>> Install wire guide tubes and wire feed rolls.
2. Connect to the AX Manager user interface (refer to "Connecting to AX Manager user interface" on page 23)
3. Configure the system
>> Configure the network, device, robot and fieldbus settings.
>> Create memory channels (apply welding programs).
>> Make a system backup, if necessary.
The integration steps are listed in more detail here: "Appendix: System integration checklist" on page 176.
Important notes
Read the instructions through carefully. For your own safety, and that of your working environment, pay particular atten-
tion to the safety instructions delivered with the equipment.
Items in the manual that require particular attention in order to minimize damage and harm are indicated with the
below symbols. Read these sections carefully and follow their instructions.
Note: Gives the user a useful piece of information.
© Kemppi
5
AX MIG Welder
Operating manual - EN
1921900 / 2318