Replacing The Access Panel - Sun Microsystems Sun Blade 1000 Service Manual

9
C H A P T E R
Finishing Replacement Procedures
This chapter describes the tasks you must do after you finish removing and
replacing internal workstation components. The chapter also explains how to
externally control standby operation.
This chapter covers the following topics:
Section 9.1, "Replacing the Access Panel" on page 9-1
Section 9.2, "Powering On the Workstation" on page 9-4
Section 9.3, "Enabling Power Management" on page 9-5
Section 9.4, "Disabling Power Management" on page 9-7
9.1

Replacing the Access Panel

Perform the following procedure to replace the access panel for the workstation.
Caution – If the access panel is installed incorrectly, the power interlock circuit will
remain activated and the workstation will not power on. Ensure that the access
panel is installed correctly.
1. Remove the antistatic strap.
2. Hold the access panel, centering it over the chassis opening (
3. Position the access panel lightly onto the chassis until the access panel hooks
engage the chassis rail.
4. Press the top edge of the access panel until it clicks into place.
5. Be sure that the access panel clicks into both sides of the chassis top.
6. Replace the lock block (if necessary) ( ).
FIGURE 9-2
).
FIGURE 9-1
9-1