Sun Microsystems Sun Blade 1000 Service Manual page 213

Caution – Avoid applying excessive force to one end or one side of the card, or
connector damage might occur.
3. At the two upper corners of the card, push the card straight down into the
connector until the card is fully seated.
Note – The graphics card connector is a double-row connector that requires two
levels of insertion. When installing the graphics card, ensure that the card is fully
seated into the connector.
4. Using a No. 2 Phillips screwdriver, replace the screw securing the bracket tab to
the workstation chassis.
5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6. Connect the video cable to the graphics card video connector.
Chapter 8 Removing and Replacing the Motherboard and Associated Components 8-27