Sun Microsystems Sun Blade 1000 Service Manual page 217

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Lay the workstation on its side.
3. Locate the DIMM(s) to be removed.
4. Press down the ejection lever at each end of the DIMM connector (
5. Lift the DIMM straight out of the connector and set it aside on the antistatic mat.
Chapter 8 Removing and Replacing the Motherboard and Associated Components
).
FIGURE 8-19
8-31