Cable Assemblies; Removing The Peripheral Power Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.3

Cable Assemblies

Use the following procedures to remove and replace these assemblies:
Peripheral power cable assembly
SCSI cable assembly
Diskette drive cable assembly
Smart card reader cable assembly
Combined cable assembly
Logo LED cable assembly
Note – Unconnected portions of the peripheral power cable assembly should
remain clipped inside the chassis.
6.3.1

Removing the Peripheral Power Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove the fan assembly and fan bracket.
See Section 6.5.1, "Removing a Fan Assembly" on page 6-21 and Section 6.6.1,
"Removing the Fan Bracket" on page 6-23.
3. Partially remove the peripheral assembly to gain access to the peripheral
connectors.
See Section 7.2.1, "Removing the Peripheral Assembly" on page 7-3.
4. Disconnect the peripheral power cable assembly as follows (
Chapter 6 Removing and Replacing Major Subassemblies
):
FIGURE 6-6
6-7