Power Switch Assembly; Removing The Power Switch Assembly - Sun Microsystems Sun Blade 1000 Service Manual

8. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.2

Power Switch Assembly

Use the following procedures to remove and replace the power switch assembly.
6.2.1

Removing the Power Switch Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove the peripheral bezel assembly by pressing on top of the bezel and tilting
it out from the workstation chassis.
3. Using a 5/16-inch nutdriver, remove the nut securing the power switch assembly
to the chassis (
4. Remove the combined cable assembly connectors from the power switch assembly
terminators.
5. Remove the power switch assembly.
).
FIGURE 6-5
Chapter 6 Removing and Replacing Major Subassemblies 6-5