Figure 7-2 Removing And Replacing The Peripheral Assembly - Sun Microsystems Sun Blade 1000 Service Manual

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove the peripheral bezel assembly by pressing down on the top of the bezel
and pulling it straight out from the chassis (
3. Using a No. 2 Phillips screwdriver, remove the four screws securing the peripheral
assembly to the chassis.
4. Partially remove the peripheral assembly from the chassis.
5. Disconnect the power and interface cables from all drives installed in the
peripheral assembly.
6. Remove the peripheral assembly from the chassis.
7. Place the peripheral assembly on an antistatic mat.
Peripheral assembly
Screw (4)
FIGURE 7-2
7-4 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Peripheral bezel assembly
Removing and Replacing the Peripheral Assembly
).
FIGURE 7-2