Removing The Scsi Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

a. Connect the peripheral power cable assembly connectors to the tape drive or
DVD-ROM drive, diskette drive, and the FC-AL backplane assembly.
b. Connect the peripheral power cable assembly connector to the motherboard
connector J3608.
3. Replace the fan assembly and fan bracket.
See Section 6.5.2, "Replacing a Fan Assembly" on page 6-22 and Section 6.6.2,
"Replacing the Fan Bracket" on page 6-24.
4. Reinstall the partially removed peripheral assembly removed earlier.
5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.3.3

Removing the SCSI Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Disconnect the SCSI cable assembly as follows (
a. Disconnect the SCSI cable assembly from the from the tape or DVD-ROM
drive.
b. Pass the SCSI cable assembly through the chassis cutout.
Lift the SCSI cable assembly out of the sheet metal cable guides.
c. Disconnect the SCSI cable assembly from the motherboard connector J5002.
d. Remove the SCSI cable assembly from the chassis.
FIGURE 6-7
Chapter 6 Removing and Replacing Major Subassemblies
):
6-9