Removing And Replacing Storage Devices; Hard Drive - Sun Microsystems Sun Blade 1000 Service Manual

7
C H A P T E R
Removing and Replacing Storage
Devices
This chapter describes how to remove and replace the Sun Blade 1000 and Sun Blade
2000 storage devices.
The chapter contains the following topics:
Section 7.1, "Hard Drive" on page 7-1
Section 7.2, "Peripheral Assembly Drives" on page 7-3
7.1

Hard Drive

Perform the following procedures to remove and replace a hard drive. If necessary,
view the ShowMe How video clip located on the Sun Blade 1000 and Sun Blade 2000
Hardware Documentation CD-ROM.
Note – When removing or replacing a hard drive, drive slot 1 is in the bottom
position of the hard drive bracket. Drive slot 2 is in the upper position of the hard
drive bracket.
Note – If only one hard drive is installed on the workstation or if you only want to
boot from a specific drive, that hard drive must be installed in drive slot 1 in the
bottom position of the hard drive bracket.
7-1