Diag-Level Variable Set To Max - Sun Microsystems Sun Blade 1000 Service Manual

To set the diag-level variable to min, type:
ok setenv diag-level min
To return to the default setting type:
ok setenv diag-level max
3.4.1

diag-level Variable Set to max

When the diag-level variable is set to max, POST enables an extended set of
diagnostic-level tests. The following code examples identify typical serial port A
POST output with the diag-level variable set to max for 2-way and single CPU
configurations:
diag-level variable set to max (2-way CPU) —
diag-level variable set to max (single CPU)
Note – The following POST examples are executed with 750 MHz CPUs and 512 MB
of memory.
3-6 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
CODE EXAMPLE 3-1
—
CODE EXAMPLE 3-2