Replacing The Power Switch Assembly - Sun Microsystems Sun Blade 1000 Service Manual

Lock washer
FIGURE 6-5
6.2.2

Replacing the Power Switch Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the power switch assembly in the chassis cutout (
2. Connect the combined cable assembly connectors to the power switch assembly
terminators.
3. Using a 5/16-inch nutdriver, replace the nut securing the power switch assembly to
the chassis.
4. Replace the peripheral bezel assembly.
6-6 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Combined cable
assembly connectors
Power switch
5/16-inch nut
Peripheral
bezel
Removing and Replacing the Power Switch Assembly
Cable route
).
FIGURE 6-5