Replacing The Audio Module Assembly - Sun Microsystems Sun Blade 1000 Service Manual

Audio module assembly
FIGURE 8-18
8.5.2

Replacing the Audio Module Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the audio module assembly into the chassis (
2. Lower the audio module assembly connector so that it touches its associated
connector on the motherboard.
3. Align the audio module assembly bracket tab with the chassis back panel slot
opening.
4. At the two upper corners of the module, push the module straight down into the
connector until the module is fully seated.
5. Using a No. 2 Phillips screwdriver, replace the screw securing the audio module
assembly to the workstation chassis.
Screw
Removing and Replacing the Audio Module Assembly
Chapter 8 Removing and Replacing the Motherboard and Associated Components
Bracket
tab
FIGURE 8-18
).
8-29