Removing A Torque Tool; Figure 8-2 Location Of Cpu Processor Slots 0 And 1, Captive Screws, And Torque Tools - Sun Microsystems Sun Blade 1000 Service Manual

CPU processor slot 0
Captive
screw(2)
FIGURE 8-2
8.2

Removing a Torque Tool

There are two types of torque tools used to install an UltraSPARC III or and
UltraSPARC III Cu CPU module into a Sun Blade 1000 or Sun Blade 2000
workstation.
Your workstation could have either torque tool A or torque tool B installed. The
torque tools are located in different locations within the workstation see
Perform the following procedure to locate and remove torque tool A or torque tool B
before removing or replacing a CPU module.
1. Power off the workstation.
See Section 5.5, "Powering Off the Workstation" on page 5-5.
8-4 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Location of CPU Processor Slots 0 and 1, Captive Screws, and Torque Tools
Torque tool A
Torque tool B
CPU processor slot 1
.
FIGURE 8-3