7. Complete one of the following steps:
Your selection depends on whether you are replacing an existing UltraSPARC III
CPU module or installing an additional UltraSPARC III CPU module into an unused
CPU processor slot.
If you are replacing an existing module and have torque tool A, perform Step 8.
If you are replacing an existing module and have torque tool B, perform Step 9.
If you are installing an additional CPU module, perform Step 10.
Left captive screw
FIGURE 8-5
8-8
Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Torque tool A
Right captive screw
Using Torque Tool A to Remove a CPU Module